Dash A/C Wiring diagram

[ronmarabito2002]

I already have planned that as a last resort. Did it once before on the 83
cruise control.

R.E. (Ron) Marabito, Dallas, TX 92WB40

--- In WanderlodgeForum@yahoogroups.com, Curt Sprenger wrote:
>
> I'll suggest finding the compressor wire near the engine compartment and
> use it to activiate another relay. The new relay use it to kick in the
> compressor.
>
> Curt Sprenger
> 1987 PT38 8V92 "MacAttack Racing"
> Anaheim Hills, CA
> curtsprenger@...
> One of the "Birds of a Feather" (BoF) Organizers
>
>
> On Thu, May 24, 2012 at 7:39 AM, ronmarabito2002 wrote:
>
> > **
> >
> >
> > Anyone out there have a wiring diagram for a 90's series Wanderlodge dash
> > A/C system.
> >
> > Looking for voltage drop between relay in upper left control center over
> > the driver back to the clutch on the compressor.
> >
> > Currently have 11.8 volts at relay and 8.6 volts at the clutch.
> >
> > If I apply 12 volts to clutch, it will pull in and hold at the 8.6 volts,
> > but will not pull in with the 8.6 volts.
> >
> > R.E. (Ron) Marabito, Dallas, TX 92WB40
> >
> >
> >
>