Hot water heater troubleshooting

[putneyflash]

make sure breaker is on, switch is red (on) on the back of the heater
is a cover held on with two screws, kill power take them out you will
see thermostat on the bottom, be careful with power on,check for
voltage at the top screw, if voltage present at top screw but not
bottom, elememt is shot. if not back up to thermostat or eco switch
all should pass votage to element. bb sells for 28.00 at home depot
they have an adaper that will adapt from the 4 hole flange into a
screw in type elemnet adapter and element is about $15.00. orr and orr
sells a 4 bolt elemnt for about $9.50
re brake



-- In WanderlodgeForum@yahoogroups.com, "bascom1968"
wrote:
> The engine heats the water, but turning on the breaker after parking
> does not result in hot water. I am getting ready to start looking
for
> the problem. Any suggestions of things to check and in what order,
> would be appreciated. Thanks, JB Lewis, 77FC31, Grand Lake,Ok.