90sp36 Onan 3cyl dcd Genset

[Henry Jay Hannigan]

---Again...I know it sounds simple but I had similar problem and air
blew switches on jenny, then jiggled them on and off a few times and
it worked. The long time sitting must have messed up my switch
contacts.....that's all I know..up to RALPH after that!
good luck,
Hank Hannigan
90SP36






In WanderlodgeForum@yahoogroups.com, "williamcharrison"
wrote:
>
> Hi all,
> I have tried suggestions from several folks re checking switches and
> presence of 12v at the stop solenoid. Switches are ok and the 12v
> required to operate the stop solenoid is present only when the start
> button is depressed. If I had a full schematic I could probably
> figure it out but I don't. Could the problem be an oil pressure
> sensor?
>