Threaded Mode | Linear Mode

11-20-2005, 10:59

Hi Robert,
We had the same problem in our '91. It was small pieces of contamination
(calcium) in the shower valve (Moen 3100). It would only feed hot water. The
balancing spool (Moen part # 1423) is a very precise device with very close
tolerances and I've cleaned it several times. Now I'm going to order a couple of
new ones (1-800-BUY-MOEN). Johannesen's Law: If I have a spare available, it
will never fail again! Hence the nickname "Packrat". Learning about these big
babies is a never ending process.I wonder if it would be worth the time to put a
good filter just after the hot water heater?

Bob Johannesen '91WLWB40, Argyle, TX

Robert & Teri Rahn wrote:
hello, we havent written in in a long time. we left mt a couple of
days ago to washington. we have been staying in our bus a couple of
days with no problems. tonight we went to take showers and there is no
hot water. actually no water flow when we put the sink on hot. from
both sinks this happens. and from the shower there is no water flow at
all on hot or cold. when the shower valve is on and the bathroom sink
is turned on there is flow out of the tub spiggot as well as the sink.
but not hot. i looked in at the water heater and there is no leak and
it sounds like it is heating, a slight sound and the top feels warm.
any help appreciated.

robert rahn
kalispell, mt
88 pt 40 wb

SPONSORED LINKS
Recreational vehicles Wanderlodge Automotive maintenance
Recreational vehicle dealer Used recreational vehicles Automotive radiators

---------------------------------
YAHOO! GROUPS LINKS

Visit your group "WanderlodgeForum" on the web.

To unsubscribe from this group, send an email to:
WanderlodgeForum-unsubscribe@yahoogroups.com

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---------------------------------

---------------------------------
Yahoo! FareChase - Search multiple travel sites in one click.

[Non-text portions of this message have been removed]