90 40WB Will Not Crank Over

[joedana0502]

I'm not sure why but the engine did start from the switch in the back.
I am sure I tried it before, anyway it starts from the back. Still
nothing from the front ignition switch. When it started I also
received an engine Alert CIS Signal Voltage High. Not sure what that
means are if that is part of the problem. I am going to buy a signal
tracer tester so I can trace out the wires. I can't see where the
wires go and I do not have a set of plans.

Joe Blankenship
90 40WB
Phoenix, AZ

--- In WanderlodgeForum@yahoogroups.com, "Gregory OConnor"
wrote:
>
> Joe, If you turn the ig. in the bus to 'on' (one click clockwise) the
> shift selector will light up. If you go in the engine compartment to
> start you must first flip a toggle in the engine compartment to 'rear'
> (That toggle has a center position that will disable both switches),
> turning the engine compartment ig. key to 'on' will only light the
> shift selector in the bus. the dash will notlight up. If none of this
> works, I would hold the 'AUX.'switch on the dash that combines all the
> batteries to one loop and try to start. I think if you try wat Mike
> and Curt said, you have weak batteries and starting on weak batteries
> is a sure way to burn a starter.
> Gregory O'Connor
> hungover and 10 lbs fatter
>