Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Eaton power sterring seal failure-twice
10-20-2005, 04:57
Post: #1
Eaton power sterring seal failure-twice
I have an Eaton model 243p power sterring pump.The front seal was
weeping and I took it in for repair.It blew the shaft seal in about
500 miles.The second time in about 800 miles.It was sent and repaired
by the same company[Hydra Steer].Thay say that it was not there
problem and that it was a system failure,air bubble,turning sterring
wheel to stop position and holding,rough roads,hitting curbs.
No contamination was found.It was set to supply 4gpm at 1750 psi.
Any coments.

Ken Kalmakoff 3208t 1982-35
Richmond, BC Canada
Quote this message in a reply
Post Reply 


Messages In This Thread
Eaton power sterring seal failure-twice - bus2nut - 10-20-2005 04:57



User(s) browsing this thread: 1 Guest(s)