Alcoa Wheels

[Leroy Eckert]

I do not know if this will help.
When I changed my valve stems I found that pre-1995 22.5" Alcoa's have a two inch round hand hole. Later models have two and one half inch handhole. It is a ten lug set up. Classifications were for motor homes and buses-diesel so one might conclude they are the same for those years. Perhaps someone else may have more info.

Leroy Eckert
1990 WB-40 Smoke N Mirrors
Dahlonega, GA
Royale Conversion

bubblerboy64 wrote:

I've been lookin' for a while and I have a lead which might work out.

Quick question. My ole 73 has the axles off a 1984 I believe. I am
assuming that the wheels will fit. The alcoa's are off a BB bus.
Before I get into this too deep would the wheels on the pushers be the
same as the FC's? I know I have not provided much information but if
the wheels on the pushers don't fit the FC's then my hunt continues. My
bus has 22.5 inch steel wheels. Ten bolt stud piloted but beyond that I
will have to reseach. Thanks in advance.
John Heckman
central Pa
1973 FC

---

Looking for last minute shopping deals? Find them fast with Yahoo! Search.