Need Video Control Center

[timvasqz]

--- In WanderlodgeForum@yahoogroups.com, "Jack and Liz Pearce"
wrote:
>
>
Satellite1 and Satellite2 if these are roofmount1 and portable2, you may need a
switch prior to the Direct-Dish receiver for a choice there ( I dont uderstand
why I was told not to have both hooked up or a dead end path?)

for all the other inputs, no swith is needed

I have a set of sony dvd/vcr players for each tv which makes the required RF
control usable.

the tv antenna can be hooked up to both sets without a need to disconnect the
other or disconnect while not in use.

the best way to set it up is to diagram a flow chart. it may well be that you
will need to input several items thru the dvr or vcr prior to the direct/dish
converter input.

older tv's have few inputs. what you see is often what input on the link to the
monitor has power and signal.
Greg
94ptca



> We use our video control center to control seven inputs to two outputs.
> We have a TV in the bedroom and a TV in the living room. I need to able
> to control roof antenna, satellite one, satellite two, cable one, cable
> two, DVR and video tape independently, for the two TVs. Regarding the
> Dish TV receiver's "how to wire" set up -- I found that a little
> inadequate.
>
> Jack
> Regards,
> Jack and Liz Pearce
> Fulltiming in a 1993 Wanderlodge WB40
> D'Hanis, TX
> Buena Vista, CO
>