Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need info for my architect / axle width, front to back dimensions etc
07-19-2019, 22:10
Post: #1
Need info for my architect / axle width, front to back dimensions etc
Hello all.

I have a new (to me) 2003 40Lx, In fact I am taking possession of it tomorrow AM.

I am getting ready to put up a steel garage (bird house). My engineer called me today asking for chassis information. I live in south Florida. Sand, more sand and water. no real hard ground unless a lot of excavation and fill.

My engineer is going to deign a concrete pad with thick reinforced concrete. He wants to know the distance between the axles and the typical load on each set.

I should be able to figure that out in a week or so. i was hoping someone here would be able to point me to this information so I can give it to him tomorrow and not hold up the works.
Any help would greatly appreciated.

Thanks, Chris Rasmussen, Fort Myers
Find all posts by this user
Like Post Quote this message in a reply
07-22-2019, 18:25
Post: #2
RE: Need info for my architect / axle width, front to back dimensions etc
The wheelbase is 248" and the GVWR is 36,100#, split 14,600# to the front and 21,500# to the rear. That should get him started.

John Mace
06 450LXi bigger bird
living in the wild hinterlands of the north
free to roam without the man getting me down
Find all posts by this user
Like Post Quote this message in a reply
[+] 2 users Like Arcticdude's post
Post Reply 




User(s) browsing this thread: 2 Guest(s)